husqvarna sew

husqvarna sew in uk

husqvarna sew uk

husqvarna sew uk.Ensure that all is clean and free of lint and jams, this is the most likely cause.
Now for tension troubleshooting.
This solution is for tension problems.
If you cannot form any sort of stitch, the issue is quite different, so please let me know if you need a different problem solved.
It is quite long, but just work through each section in order.
If you have loose threads on one side or the other, the tension on the opposite side will be the culprit.
Balance bobbin to suit.
If the looping threads are on the underside as you sew, it is the top tension.
If you are using a needle that has seen quite a deal of work, or you suspect it may be blunt, change it for a new one!
It may be there is lint trapped between the discs, this will keep them slightly apart and reduce the actual tension, sometimes dramatically.
If tensions appear correct, and the thread is definitely in the channel between the discs, but still too loose and looping, try raising presser foot and remove your thread.
Do not gouge or score the plates, they need a polished surface to work correctly.
This is just good housekeeping, my wife does this every time she replaces the bobbin.
Just take it out and clean the bobbin case and the fixed metal hook race with a small brush to remove lint.
If there is a significant amount of lint, use a vacuum and small brush to get the worst.
Oil and lint combine to conspire against you.
If it seems likely that you.
To adjust the bobbin case, first check there is no lint trapped in the metal spring where the thread is tensioned.
The other screw at one end is holding it all together, so beware.
It is not a tragedy to undo the whole lot and clean it, but very gingerly and lay the bits out in sequence and orientation, or you risk tearing your hair out!
Try using good quality thread of contrasting colours so you can more easily spot the changes.
You may find you are playing with this balance for some little while and if you are putting the needleplate on and off each time begin to think it cannot be correct to do this.
Then make some sort of cover!
Ï»¿ if you have open yarns on one position or the other the tension on the opposite position will be the culprit.
If stress seem right and the thread is definitely in the channel between the discs but still too loose and looping try raising presser foot and remove your thread.
To set the spool showcase first check there is no lint trapped in the metal spring where the thread is tensioned.
Ï»¿ if stress seem right and the thread is definitely in the channel between the discs but still too loose and looping try raising presser foot and remove your thread.
To set the spool showcase first check there is no lint trapped in the metal spring where the thread is tensioned.
Ï»¿ to set the spool showcase first check there is no lint trapped in the metal spring where the thread is tensioned.. husqvarna sew

husqvarna sewing machin... (4:00:42)
1,384 views
"www.guideandinformations.com guide and informations about viking husqvarna sewing mac..."